WAN

• Dual-modem capable with optional COR Extensibility Dock
• Integrated 600M LTE Advanced 600 Mbps modem (with DC-HSPA+ failover)
• Integrated LP6 300Mbps LTE Advanced LTE modem (with DC-HSPA+ failover) or LP5 300Mbps LTE Advanced LTE • modem (with DC-HSPA+ failover)
• Two LAN/WAN switchable 10/100/1000 Gigabit Ethernet ports – one default WAN (cable/DSL/T1/satellite/Metro • Ethernet)
• WiFi as WAN, Metro WiFi; 2×2 MIMO “N” 2.4 GHz or 5 GHz; 802.11 a/b/g/n/ac wave 2 (IBR900 only)
• Integrated LPE 100Mbps 4G LTE/HSPA+/EVDO with 3G CDMA/EVDO fallback for Verizon and Sprint

LAN

• Dual-band, dual-concurrent WiFi; 802.11 a/b/g/n/ac wave 2 (IBR900 only)
• Two LAN/WAN switchable 10/100/1000 Gigabit Ethernet ports – one default LAN
• Serial console support for Out-of-Band Management of a connected device

PORTS

• Power
• 2-wire GPIO
• Add more GPIO ports with optional 9-wire GPIO cable or COR Extensibility Dock (see Accessories section below)
• USB 2.0
• Two Ethernet LAN/WAN
• Two cellular antenna connectors (SMA)
• One active GPS antenna connector (SMA)
• Two WiFi antenna connectors (R-SMA)
• 15-pin dock port for COR Extensibility Dock or 9-wire GPIO cable

TEMPERATURE

• -30 °C to 70 °C (-22 °F to 158 °F) operating with optional* 9-wire power and GPIO cable (Part #170680-000)
• -30 °C to 70 °C (-22 °F to 158 °F) operating with optional extended temperature AC power supply (Part #170648- 000; see this page for line cord details)
• -20 °C to 60 °C (-4 °F to 140 °F) operating with included† standard AC power supply
• -40 °C to 85 °C (-40 °F to 185 °F) storage
• * - included with “-NPS” version, † - not included with “-NPS” version

HUMIDITY (non-condensing)

• 5% to 95% operating
• 5% to 95% storage

POWER

• DC input steady state voltage range: 9–33 VDC (requires inline fuse for vehicle installations)
  • For 9–24 VDC installations, use a 3 A fuse
  • For > 24 VDC installations, use a 2.5 A fuse
• Reverse polarity and transient voltage protection per ISO 7637-2
• Ignition sensing (automatic ON and time-delay OFF)
• Power consumption:
  • Idle: 4W
  • WiFi Tx/Rx: 9 W
  • LTE Tx/Tx: 6.25 W
  • 12 VDC / 2 A adapter recommended

WIFI POWER

• 2.4 GHz: 18 dBm conducted
• 5 GHz VHT20: 17.5 dBm conducted
• 5 GHz VHT40: 17 dBm conducted
• 5 GHz VHT80: 16.5 dBm conducted

SIZE AND WEIGHT

• Size: 4.6 × 4.5 × 1.2 in (118 × 113.5 × 29.3 mm)
• Weight: 14 oz (400 g)

Certifications:

• FCC, CE, IC
• AS, NZS, SGP (IMDA)
• WiFi Alliance (IBR900 only) – 802.11a/b/g/n/ac wave 2 certified
• Safety: UL/CUL, CB Scheme, EN60950-1
• Shock/Vibration/Humidity: compliant with MIL STD 810G and SAEJ1455
• Ingress Protection: compliant with IP54 (includes protection from dust and splashing water)
• Materials: WEEE, RoHS, RoHS-2, California Prop 65
• Telecom: PTCRB/CTIA, GCF-CC
• Regulatory Models: S5A643A, S5A644A, S5A648A, S5A701A, S5A706A
• FIPS 140-2 Inside

GPS:

• GPS Protocols: TAIP and NMEA 0183 V3.0
• Satellite channels: Maximum 55 channels, simultaneous tracking
• Concurrent standalone GPS, GLONASS, BeiDou and Galileo
• 1 Hz refresh rate
• Accuracy:
  • < 2 m: 50%
  • < 5 m: 90%
  • Horizontal: < 2 m (50%); < 5 m (90%)
  • Altitude: < 4 m (50%); < 8 m (90%)
  • Velocity: < 0.2 m/s
• Acquisition (measured with signal strength = -145 dBm)
  • Hot start: 1 second
  • Warm start: 29 seconds
  • Cold start: 32 seconds
• Sensitivity
  • Tracking: -160 dBm (tracking sensitivity is the lowest GNSS signal level for which the device can still detect an in-view satellite 50% of the time when in sequential tracking mode)
  • Acquisition (standalone): -145 dBm (acquisition sensitivity is the lowest GNSS signal level for which the device can still detect an in-view satellite 50% of the time)
• Operational limits: altitude < 6000 m or velocity < 100 m/s (either limit may be exceeded, but not both)